/*
 * Created by Ben V. Brown
 */

#include "Modes.h"
#include "Bios.h"
#include "MMA8652FC.h"
#include "PID.h"
#include "Oled.h"
#include "Settings.h"
#include "I2C.h"
void setup();

int main(void) {
	setup();/*Setup the system*/
	while (1) {
		Clear_Watchdog(); //reset the Watch dog timer
		ProcessUI();
		DrawUI();
		delayMs(50); //Slow the system down a little bit
	}
}
void setup() {
	RCC_Config(); 										//setup system clock
	NVIC_Config(0x4000); 								//this shifts the NVIC table to be offset, for the usb bootloader's size
	GPIO_Config(); 										//setup all the GPIO pins
	Init_EXTI(); 										//Init the EXTI inputs
	Init_Timer3(); 										//Used for the soldering iron tip
	Adc_Init(); 										//Init adc and DMA
	I2C_Configuration();								//Start the I2C hardware
	GPIO_Init_OLED();									//Init the GPIO ports for the OLED
	restoreSettings();									//Load settings

	StartUp_Accelerometer(systemSettings.sensitivity); 	//start the accelerometer

	setupPID(); 										//Init the PID values
	readIronTemp(systemSettings.tempCalibration, 0,0); 	//load the default calibration value
	Init_Oled(systemSettings.flipDisplay); 				//Init the OLED display

	OLED_DrawString("VER 1.03", 8); 					//1.settings version as of current
	delayMs(800);										//Pause to show version number
	Start_Watchdog(1000); 								//start the system watch dog as 1 second timeout
}