blob: 60c730a01a1ff86937400295567c6261da77d7a6 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
|
# Version Changes
V2.00
* Complete re-write of the low layer system to use the STM32 HAL for easier development
* This allowed easier setup for the new ADC auto measuring system
* Better tip PWM control
* Moved to FreeRTOS for scheduling
* Complete re-write from blank
* Added detailed screen views
* Added smaller font for said screen views
V1.17
* Added blinking cooldown display
* Allowed smaller sleep timeout values
* New font!
* Automatic startup option
V1.16
* Added automatic rotation support
* Added power display graph
V1.15
* Added support for a custom bootup logo to be programmed via the DFU bootloader.
V1.14
* Changed input voltage cutoff to be based on cell count rather than voltage.
V1.13
* Swapped buttons for menu to prevent accidentally changing first menu item
* Added auto key repeat.
V1.12
* Increases sensitivity options to be 1*9 with 0 off state
* Fixes issue where going from COOL *> soldering can leave screen off.
V1.11
* Boost mode
* Change sensitivity options to be 1*8
V1.10
* Adds help text to settings
* Improves settings for the display update rate
V1.09
* Adds display modes, for slowing down or simplifying the display
V1.08
* Fix settings menu not showing flip display
V1.07
* Adds shutdown time to automatically shutdown the iron after inactivity
V1.06
* Changes H and C when the iron is heating to the minidso chevron like images
V1.05
* Adds ability to calibrate the input voltage measurement
V1.04
* Increased accuracy of the temperature control
* Improved PID response slightly
* Allows temperature offset calibration
* Nicer idle screen
V1.03
* Improved Button handling
* Ability to set motion sensitivity
* DC voltmeter page shows input voltage
V1.02
* Adds hold both buttons on IDLE to access the therometer mode.
* Changes the exit soldering mode to be holding both buttons (Like original firmware).
|
