blob: cbbbed96d263b0c540f16dd142227a50fbce17a7 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
|
/*
* Settings.h
*
* Created on: 29 Sep 2016
* Author: Ralim
*
* Houses the system settings and allows saving / restoring from flash
*/
#ifndef SETTINGS_H_
#define SETTINGS_H_
#include <stdint.h>
#include "stm32f10x_flash.h"
#define SETTINGSVERSION 12 /*Change this if you change the struct below to prevent people getting out of sync*/
//Display Speeds
#define DISPLAYMODE_FAST (0x00)
#define DISPLAYMODE_MEDIUM (0x01)
#define DISPLAYMODE_SLOW (0x02)
//Rounding Modes
#define ROUNDING_NONE (0x00)
#define ROUNDING_FIVE (0x01)
#define ROUNDING_TEN (0x02)
/*
* This struct must be a multiple of 2 bytes as it is saved / restored from flash in uint16_t chunks
*/
struct {
uint16_t SolderingTemp; //current set point for the iron
uint32_t SleepTemp; //temp to drop to in sleep
uint8_t version; //Used to track if a reset is needed on firmware upgrade
uint8_t SleepTime; //minutes timeout to sleep
uint8_t cutoutVoltage:5; //The voltage we cut out at for under voltage
uint8_t displayTempInF:1; //If we need to convert the C reading to F
uint8_t flipDisplay:1; //If true we want to invert the display for lefties
uint8_t sensitivity:6; //Sensitivity of accelerometer (5 bits)
uint8_t ShutdownTime:6; //Time until unit shuts down if left alone
uint8_t displayUpdateSpeed:2; //How fast the display updates / temp showing mode
uint8_t temperatureRounding:2; //Rounding mode for the temperature
uint8_t boostModeEnabled:1; //Boost mode swaps BUT_A in soldering mode to temporary soldering temp over-ride
uint16_t tempCalibration; //Temperature calibration value
uint16_t voltageDiv; //Voltage divisor factor
uint16_t BoostTemp; //Boost mode set point for the iron
} systemSettings;
void saveSettings();
void restoreSettings();
void resetSettings();
#endif /* SETTINGS_H_ */
|
