Update GettingStarted.md

1 files changed, 1 insertions, 1 deletions

diff --git a/Documentation/GettingStarted.md b/Documentation/GettingStarted.md
index a28fee1e..8e362e93 100644
--- a/Documentation/GettingStarted.md
+++ b/Documentation/GettingStarted.md
@@ -65,7 +65,7 @@ Pinecil has an unpopulated footprint (U14) for a hall effect sensor (Si7210). Pi
   - Setting of 9 would be useful if you only had a small magnet and are not concerned about Pinecil falsely triggering sleep mode near magnetized items/tools.
   - Neodymium magnets are recommended. If using small magnets, multiple may be required, but too many can also be detrimental because it deforms the shape of the field away from the sensor.
   - Actively watch the changing hall number (in [debug menu](/Documentation/DebugMenu.md)) while you slowly move the magnet around to seek the best locations & whether you have too many or too few magnets. Positioning the magnet where you have the highest hall number will ensure consistent sleep mode when you place the iron in the stand.
-  - The Hall Sensor is physically located near the copper contacts for the tip at the front of the handle. Reference [Schematics U14](https://files.pine64.org/doc/Pinecil/Pinecil_schematic_v1.0a_20201120.pdf)
+  - The Hall Sensor is physically located near the copper contacts for the tip at the front of the handle. Reference [Schematics U14](https://files.pine64.org/doc/Pinecil/Pinecil_schematic_v1.0a_20201120.pdf).
 
 ### Idle shutdown