blob: 0eb91989abb95501a4904036f7d7880e977f7a8b (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
|
//go:build stm32wlx
// +build stm32wlx
package machine
import (
"device/stm32"
)
//
// This variant of the GPIO input interrupt logic is for
// multi-core chips with a larger number of interrupt
// channels (more than fits in a single register).
//
// This logic is currently used by the single-core stm32wle5
// due to a patch in stm32-rs project that has renamed the
// registers to match the dual-core names. This renaming is
// being discussed and may change in future.
//
//
// STM32 allows one interrupt source per pin number, with
// the same pin number in different ports sharing a single
// interrupt source (so PA0, PB0, PC0 all share). Only a
// single physical pin can be connected to each interrupt
// line.
//
// To call interrupt callbacks, we record here for each
// pin number the callback and the actual associated pin.
//
// Callbacks for pin interrupt events
var pinCallbacks [16]func(Pin)
// The pin currently associated with interrupt callback
// for a given slot.
var interruptPins [16]Pin
// SetInterrupt sets an interrupt to be executed when a particular pin changes
// state. The pin should already be configured as an input, including a pull up
// or down if no external pull is provided.
//
// This call will replace a previously set callback on this pin. You can pass a
// nil func to unset the pin change interrupt. If you do so, the change
// parameter is ignored and can be set to any value (such as 0).
func (p Pin) SetInterrupt(change PinChange, callback func(Pin)) error {
port := uint32(uint8(p) / 16)
pin := uint8(p) % 16
enableEXTIConfigRegisters()
if callback == nil {
stm32.EXTI.C1IMR1.ClearBits(1 << pin)
pinCallbacks[pin] = nil
return nil
}
if pinCallbacks[pin] != nil {
// The pin was already configured.
// To properly re-configure a pin, unset it first and set a new
// configuration.
return ErrNoPinChangeChannel
}
// Set the callback now (before the interrupt is enabled) to avoid
// possible race condition
pinCallbacks[pin] = callback
interruptPins[pin] = p
crReg := getEXTIConfigRegister(pin)
shift := (pin & 0x3) * 4
crReg.ReplaceBits(port, 0xf, shift)
if (change & PinRising) != 0 {
stm32.EXTI.RTSR1.SetBits(1 << pin)
}
if (change & PinFalling) != 0 {
stm32.EXTI.FTSR1.SetBits(1 << pin)
}
stm32.EXTI.C1IMR1.SetBits(1 << pin)
intr := p.registerInterrupt()
intr.SetPriority(0)
intr.Enable()
return nil
}
|
